Replacement Part List

IMPORTANT
Please read these instructions carefully before you start to assemble this product .
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Safety advice
For safety purposes we strongly recommend the product to be assembled by at least 2 people.
Some parts may have sharp edges. Please be careful when handling components. Always wear
gloves, eye protection, and long sleeves when assembling or performing any maintenance on
your product.
Do not attempt to assemble the product in windy or wet conditions.
Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
Dispose of all plastic bags safely - keep them away from children's reach.
Keep children away from the assembly area.
When using a stepladder or power tools, make sure that you are following
the manufacturer's safety advice.
Do not climb or stand on the roof.
Do not hang or lay on the profiles.
Heavy articles should not be leaned against the poles.
Keep roof and gutters clear of snow, dirt & leaves.
Heavy snow load on the roof can make it unsafe to stand below or nearby.
If color was scratched during assembly it can be fixed.
Cleaning instructions
In order to clean the product, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or other special detergents to clean the panels.
Clean the product once assembly is complete.
Before starting assembly
Choose your site carefully before beginning assembly.
The ground surface must be perfectly flat and leveled and have a solid base such
as concrete or asphalt.
Sort the parts and check against the content parts list.
Parts should be laid out close at hand. Keep all small parts (screws etc.) in a bowl so they do
not get lost.
Please consult your local authorities if any permits are required prior to constructing the product.
The drawings in this manual are designed for Arcadia 4300 (12'x 14'), Arcadia 5000 (12'x 16'),
Arcadia 6400 (12'x 21') products + 0.7 or 2.1 Extension Kits.
Please note that content list refers only to one set of 2 pole extensions.
During Assembly
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
Attention
During assembly use a soft surface below the parts to avoid scratches and damages.
M Steps
Step 1: The Arcadia Alpine Kit can be set at two optional heights.
Step 6: After completing the assembly of the Arcadia Alpine Kit, please revert back to the
Arcadia assembly instructions and continue the assembly from Steps 3 - 41.
Step 7: Make sure the poles' foot pads are leveled prior to tightening the screws,
use a spirit level.
Step 8: Make sure the product is square by measuring the diagonals.
Make sure the product is level by using a spirit level. Use the supplied screws and plugs for
concrete or asphalt foundation.
Tighten all screws at the end of assembly.
Note:
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.