Operating Instructions

58
Dubbing
Use the dubbing function to copy the contents of S-
VHS (or VHS) cassettes onto DV cassettes or
record the television.
1 Connect this unit to a video deck or a
television. (Page 55)
2 Press the CAMERA/VCR button and switch to
the VCR mode.
3 Turn on the power of the external unit, and play
back the tape.
4 To start recording video signals from the
connected devices, press two VCR REC
buttons at a time.
On the remote control, while pressing the REC
button, press the PLAY button.
• If you press these two buttons during pause,
the unit will go to shooting standby mode.
Each time the [h] button of the OPERATION
lever is pressed, the unit switches between
shooting and the shooting standby mode.
5 Move the OPERATION lever [g] to stop
recording.
6 Stop playback on the external unit.
Analog/digital (AD) conversion
You can use this unit to convert analog to digital
signals. In the setup menus, AV IN/OUT SETUP
screen, set DV OUT to “ON”. (Page 75)
This enables you to output digital images, which
were input as analog signals from an external unit,
through this unit’s DV connector to another digital
video unit.
• Normally, set DV OUT to “OFF”. Images may be
disrupted if you set it to “ON”.
• You can also use an S-video cable.
• Connecting external units (Page 53)
Analog input
You cannot adjust the audio level.
CAMERA
VCR
COUNTER RESET TITLE
STILL ADV PAUSE STILL ADV
INDEX
— VOL +
STOP INDEX
MULTI/
P-IN-P
REC A.DUB
PLAY/REW FF/
ZOOM
VCR REC buttons
Remote controlor
Analog signals
Digital signals
Video deck, etc.
Another digital video
unit
This camera-
recorder
Camera