Operating Instructions

112
Chapter 6 Manipulating Clips with Thumbnails
3
Use the cursor buttons to move the pointer to
the item to confirm and press the SET button.
• Use this function to check loaded metadata
settings.
4
While viewing metadata settings, use the cursor
buttons to move the pointer to the desired
option. Then, press the SET button.
• A soft keyboard screen is displayed, allowing you
to modify the setting.
To set whether or not the uploaded
metadata is recorded
Set “ON”/“OFF” in META DATA  RECORD from the
thumbnail menu. The factory setting is “OFF”.
Selecting the USER CLIP NAME recording
method
Select META DATA  USER CLIP NAME from the thumbnail
menu to select the recording method. Two options are
available: TYPE1 and TYPE2.
TYPE1(Factory defaults)
USER CLIP NAME to be
recorded
If clip metadata has been
read in
Uploaded data
If no clip metadata has been
read in or if the setting for
recording clip metadata has
been turned off
Same as GLOBAL CLIP ID
(UMID data)
TYPE2
USER CLIP NAME to be
recorded
If clip metadata has been
read in
Uploaded data + COUNT
value
*1
If no clip metadata has been
read in or if the setting for
recording clip metadata has
been turned off
Same as CLIP NAME
*1 The COUNT value is indicated as a four-digit number.
The COUNT value is incremented each time a new clip
is captured if clip metadata has been read in and TYPE2
has been selected as the recording method.
The COUNT value can be reset using the following
procedure.
Select META DATA  PROPERTY from the thumbnail
menu, then select USER CLIP NAME to display the
menu shown below. Select “COUNT RESET” with the
cursor and press the SET button to reset the COUNT
value to 1.
 NOTE
When an 8 GB or larger capacity P2 is used and the
recording session exceeds the prescribed duration
(DVCPRO HD and the AVCIntra100: about 5 minutes;
AVC-Intra50: about 10 minutes) or spans more than one P2
card, the recording will automatically be split into separate
clips. At this time, each clip will be provided with its own
COUNT value.