Operating Instructions

129
Chapter 7 Menu Operations
Item Setting Notes
AUTO KNEE SW Selects the function of the OUTPUT/AUTO KNEE.
ON: Setting AUTO KNEE to ON turns on the AUTO
KNEE function.
OFF: The AUTO KNEE function is not available even
when AUTO KNEE is set to ON.
DRS: Setting AUTO KNEE to ON turns on the DRS
(Dynamic Range Stretcher) function. (For details, refer
to page 9.)
• Selecting the 1/15 and 1/30
shutter speeds in the 1080/30P,
1080/24P1080/60i modes and setting
AUTO KNEE to ON will activate the
AUTO KNEE function even if DRS has
been set.
RECORDING SETUP screen
Item Setting Notes
REC FUNCTION Sets special recording modes.
NORMAL: The special recording modes are not used.
INTERVAL: Sets interval recording.
ONE SHOT: Sets one-shot recording.
LOOP: Sets loop recording.
For details, refer to [Special Recording Modes]
(page 39).
• This function is always set to NORMAL when the
power is turned on.
• Not available in the following
conditions.
- When REC SIGNAL is set to 1394
- When REC FORMAT is set to native
recording.
- When SYSTEM MODE is set to
1080-59.94i or 480-59.94i; and
CAMERA MODE is set to 24P or
24PA.
ONE SHOT TIME Sets the time interval for one-shot recording.
1frm, 2frm, 4frm, 8frm, 16frm, 1s
For details, refer to [One shot recording (ONE SHOT
REC)] (page 40).
• Not available when REC FUNCTION is
set to ONE SHOT.
INTERVAL TIME Sets the time interval of interval recording.
2frm, 4frm, 8frm, 16frm, 1s, 2s, 5s, 10s, 30s, 1min,
5min, 10min
For details, refer to [Interval recording (INTERVAL
REC)] (page 40).
• Not available when REC FUNCTION is
set to INTERVAL.
START DELAY This delays the start of interval and one-shot recording
by about 1 second.
ON, OFF
• Not available when REC FUNCTION is
set to INTERVAL or ONE SHOT.
PREREC MODE Sets PRE REC.
ON, OFF
For details, refer to [Pre-recording (PRE REC)]
(page 39).
• Not available in the following
conditions.
- When REC SIGNAL is set to 1394
- When SYSTEM MODE is set to 720-
59.94P and VFR is set to ON.
- When REC FORMAT is set to native
recording.
- When SYSTEM MODE is set to 1080-
59.94i or 480-59.94i; and CAMERA
MODE is set to 24P or 24PA.
- When REC FUNCTION is set to
something other than NORMAL.
- When the VFR option is set to ON.
TC MODE Sets count correction when using the internal time
code generator.
DF: Drop frame time code
NDF: Non drop frame time code
For details, refer to [Setting the Time Code] (page 60).
• Not available when operating at 24P,
24PA and 24PN. Then NDF is counted
at all times.
UB MODE Sets the data recorded in the camera user bits.
USER, TIME, DATE, EXT, TCG, FRM.RATE
For details, refer to [Setting user bits] (page 58).
____ indicates the factory setting