Operating Instructions

130
Chapter 7 Menu Operations
AUDIO SETUP screen
Item Setting Notes
FRONT VR CH1 Enables/disables Front Audio Level control of CH1
input.
FRONT: Enables Front Audio Level control of
microphone input to CH1.
W.L.: Enables Front Audio Level control of audio from
a wireless receiver input to CH1.
REAR: Enables Front Audio Level control of rear input
that is input to CH1.
ALL: Enables Front Audio Level control when front,
wireless, rear and other inputs are input to CH1.
OFF: Disables Front Audio Level control of CH1.
• When the AUDIO SELECT CH1 switch
is set to AUTO and auto adjustment
mode is active, the Front Audio Level
control is disabled regardless of these
settings.
FRONT VR CH2 Enables/disables Front Audio Level control of CH2
input.
Same setting as FRONT VR CH1.
OFF (factory default setting)
• When the AUDIO SELECT CH2 switch
is set to AUTO and auto adjustment
mode is active, the Front Audio Level
control is disabled regardless of these
settings.
MIC LOWCUT CH1
*1
Sets the CH1 microphone low-cut filter.
FRONT: Operates for the front microphone input.
W.L.: Operates for wireless receiver input.
REAR: Operates for the rear microphone input.
OFF: Turns off the filter for all inputs.
MIC LOWCUT CH2
*1
Sets the CH2 microphone low-cut filter.
Same setting as MIC LOWCUT CH1.
OFF (factory default setting)
MIC LOWCUT CH3
*1
Sets the CH3 microphone low-cut filter.
Same setting as MIC LOWCUT CH1.
OFF (factory default setting)
MIC LOWCUT CH4
*1
Sets the CH4 microphone low-cut filter.
Same setting as MIC LOWCUT CH1.
OFF (factory default setting)
LIMITER CH1 Sets the CH1 limiter.
ON, OFF
• When the AUDIO SELECT CH1 switch
is set to AUTO and auto adjustment
mode is active, the limiter is disabled
regardless of these settings.
LIMITER CH2 Sets the CH2 limiter.
ON, OFF
• When the AUDIO SELECT CH2 switch
is set to AUTO and auto adjustment
mode is active, the limiter is disabled
regardless of these settings.
AUTO LEVEL CH3 Selects the method for setting CH3 level.
ON: Engages the auto adjustment mode. The limiter is
not available.
OFF: Locks the level. (The limiter operates lines other
than the rear line.)
AUTO LEVEL CH4 Selects the method for setting CH4 level.
Same setting as AUTO LEVEL CH3.
ON (factory default setting)
*1 The frequency characteristics for a microphone low-cut filter is 200 Hz – 10 kHz.
____ indicates the factory setting