Operating Instructions

131
Chapter 7 Menu Operations
Item Setting Notes
25M REC CH SEL Selects the audio channels to be recorded in the
DVCPRO and DV formats.
2CH: Only recorded on CH1 and CH2.
4CH: Records on all four channels.
• Not available in the following
conditions.
- When SYSTEM MODE is 1080i-59.94i
or 720-59.94P.
- Available only when SYSTEM
MODE is set to 480-59.94i and REC
FORMAT is set to the DVCPRO50
codec.
- REC SIGNAL is set to 1394
(operation depends on 1394 input
status).
TEST TONE Selects the test signal.
NORMAL: Outputs test tones to channels 1, 2, 3 and
4 when the OUTPUT/AUTO KNEE selector switch is
set to BARS and the AUDIO IN switch CH1 is set to
FRONT.
ALWAYS: Outputs test tones to channels 1, 2, 3 and
4 at all times when the OUTPUT/AUTO KNEE selector
switch is set to BARS.
CHSEL: Outputs test tones to channels selected by
setting the AUDIO IN switch CH1 or CH2 to FRONT
and the OUTPUT/AUTO KNEE selector switch is set to
BARS. (Test tones are not output to CH3 and CH4.)
OFF: Does not output a test tone.
F.MIC POWER Turns on and off the phantom power supply for the
front microphone.
ON, OFF
R.MIC POWER Turns on and off the phantom power supply for the
rear microphone.
ON: Turns on the phantom power supply to the
microphone when the rear LINE/MIC/+48V switch is
set to +48V.
OFF: Does not supply phantom power to the
microphone even when the rear LINE/MIC/+48V switch
is set to +48V.
MONITOR SELECT Switches the output signal to AUDIO OUT, earphones
and speaker when the MONITOR SELECT switch is
set to ST.
STEREO, MIX
F.MIC LEVEL Selects the input level for the front microphone.
–40dB, –50dB, –60dB
R.MIC CH1 LEVEL Selects the input level for the rear microphone
connected to CH1.
–50dB, –60dB
R.MIC CH2 LEVEL Selects the input level for the rear microphone
connected to CH2.
–50dB, –60dB
HEADROOM Sets the headroom (standard level).
18dB, 20dB
WIRELESS WARN Sets whether a warning should be output when
wireless receiver reception is poor.
ON, OFF
WIRELESS TYPE Selects wireless receiver type.
SINGLE: 1-channel receiver
DUAL: 2-channel receiver
• When DUAL is selected for a 1-channel wireless
receiver, CH2 and CH4 will stay mute.
1394 AUDIO OUT Selects audio channel output to 1394 OUT in DVCPRO
or DV mode.
CH1/CH2, CH3/CH4
• Available only when SYSTEM MODE is
set to 480-59.94i and REC FORMAT is
set to DVCPRO or DV.
____ indicates the factory setting