Operating Instructions

148
Chapter 9 Maintenance and Inspections
Inspecting the Memory Recording
Functions
Make sure you successively carry out the inspections from
[Inspecting the P2 Card Recording] to [Inspecting the
Earphone and Speaker].
Inspecting the P2 Card Recording
1
Check on the display inside the viewfinder that
the remaining P2 card recording capacity is
sufficient.
For details, refer to [Screen displays] (page 66).
2
Press the camera’s REC button to check the
following items:
• The P2 access LED blinks in orange.
• The REC indication in the viewfinder lights.
• System warnings do not appear inside the
viewfinder.
3
Press the camera’s REC button again.
• Check that the P2 access LED lights orange and
that REC indication in the viewfinder clears.
4
Using the REC button on the handle, repeat
Steps 2 to 3 to check the same operation.
• Check the VTR button on the lens in the same way.
5
Press the THUMBNAIL button to switch
the thumbnail screen to play back currently
recorded clip from thumbnail.
• Check that playback is operating normally.
6
Use the USER button to which the SLOT SEL
function has been assigned to select P2 cards
for recording when more than one P2 card is
inserted in the card slots.
• Repeat the operations in Steps 2 to 3 and 5
to check that recording and playback operate
properly.
Inspecting the Audio Level Automatic
Adjustment
1
Set the AUDIO SELECT CH1 and CH2
switches to [AUTO].
2
Set the AUDIO IN switch to [FRONT].
3
Aim the microphone connected to the MIC IN
jack at an appropriate sound source. Then,
check that the level displays for both CH1 and
CH2 change according to the sound level.
Inspecting the Audio Level Manual
Adjustment
1
Set the AUDIO IN switch to [FRONT].
2
Set the AUDIO SELECT CH1 and CH2
switches to [MAN].
3
Turn the AUDIO LEVEL CH1 and CH2 controls.
• Check that the level display increases when the
controls are turned to the right.
Inspecting the Earphone and Speaker
1
Turn the MONITOR control to check that the
speaker volume changes.
2
Connect an earphone to the PHONES jack.
• Check that the speaker is turned off and the
microphone sound can be heard from the
earphone.
3
Turn the MONITOR control to check that the
earphone volume changes.