Operating Instructions

86
Chapter 5 Preparation
Chapter 5 Preparation
Power Supply
A battery or an external DC power supply can be used as
the power supply for the camera-recorder.
Using a Battery
The following is a list of batteries that have been tested and
verified to work with the camera.
Anton/Bauer batteries
PROPAC14, TRIMPACK14
HYTRON50, HYTRON140
DIONIC90, DIONIC160
IDX batteries
NP-L7, ENDURA7, ENDURA10
Sony batteries
BP-GL65/95
PAG batteries
PAGL95
 NOTE
• Although other batteries may be used by changing the menu
setting, it is recommended that you use batteries that have
been tested and verified to work with camera.
• Charge the battery with the battery charger before using it.
(Please refer to the battery charger’s instruction manual for
information about charging.)
Mounting the Battery and Setting
the Battery Type
Using an Anton/Bauer Battery
1
Mount an Anton/Bauer battery.
Lighting control switch
Power supply output connector for lighting
Anton/Bauer Battery
 NOTE
The Anton/Bauer battery holder includes both a power
supply output connector for lighting and a lighting
control switch, which are convenient when attaching a
light. Please contact Anton/Bauer for information about
the lighting system.
2
Insert the battery and slide it in the direction of
the arrow.
Release lever
 NOTE
Removing the battery
Completely push down and hold the release lever
on the battery holder. Then, slide the battery in the
opposite direction to the arrow while holding the lever
down.
3
Set the battery type.
• Select the battery type listed under BATTERY
SELECT. Select the menu option BATTERY
SELECT from the setting menu BATTERY SETUP
screen.