Operating Instructions

89
Chapter 5 Preparation
Mounting and Adjusting the Lens
Mounting the Lens
1
Raise the lens clamping lever and remove the
mount cap.
Mount Cap
Lens Clamping Lever
2
To mount the lens, align the indentation at the
top center of the lens mount with the center
mark of the lens.
Mark
3
Lower the lens lever to firmly tighten the lens.
4
Secure the cable through the cable clamp, and
plug it into the LENS connector.
LENS Connector
Cable
clamp
5
Adjust the lens flange back.
For details, refer to [Adjusting the Lens Flange
Back] (page 90).
 NOTE
• Please refer to the lens instruction manual for
guidance on lens handling.
• When the lens is removed, install the mount cap to
protect the device.