Operating Instructions

91
Chapter 5 Preparation
White Shading Compensation
The camera can use DEFAULT (fixed value) and three user
adjustable functions (USER1, USER2, USER3) to store
white shading compensation data.
Select SHADING SELECT in the setting menu LENS SETUP
screen to set compensation data. Selecting OFF turns off
shading compensation.
Selecting White Shading Compensation
Data
1
Select SHADING SELECT in LENS SETUP,
then press the JOG dial button.
For details on menu operation, refer to [Using the
menus] (page 120).
PUSH MENU TO RETURN
SHADING(USER)
CAC
CAC PROPERTY
CAC CARD READ
CAC FILE DELETE
CAC FILE INIT
DEFAULT
>>>
ON
>>>
>>>
IRIS ADJUST >>>
>>>
>>>
SHADING SELECT
LENS SETUP
2
Use the JOG dial button to select DEFAULT,
USER1, USER2, USER3 or OFF and press the
JOG dial button.
• To adjust the white shading, select USER1, USER2
or USER3.
• The USER1, USER2 or USER3 settings do not
contain any compensation data by default.
• DEFAULT stores compensation data that suits
XT17x4.5BRM-K14. For lenses other than those
above, perform the “White Shading Adjustment”
described below.
PUSH MENU TO RETURN
SHADING(USER)
CAC
CAC PROPERTY
CAC CARD READ
CAC FILE DELETE
CAC FILE INIT
DEFAULT
USER1
USER2
USER3
OFF
IRIS ADJUST >>>
>>>
>>>
SHADING SELECT
LENS SETUP
White Shading Adjustment
 NOTE
Coloring may occur in the vertical direction near the open
setting of the lens iris even when the white shading has been
adjusted. This is an optical characteristic and not indicative of
a failure.
1
Place the camera in the adjustment mode.
(1) Mount a lens on the camera.
• Do not forget to connect the lens cable.
(2) Turn the shutter switch off and set 0 dB gain.
(3) If the lens comes with an extender, disengage it.
(4) Open the setting menu LENS SETUP screen
and select USER1, USER2 or USER3 under
SHADING SELECT.
(5) Use the JOG dial button to select SHADING
(USER), select EXECUTE and press the JOG dial
button.
• The message “CHECK LUMINANCE LEVEL
ZEBRA ON VF” appears.
PUSH MENU TO RETURN
SHADING(USER)
CAC
CAC PROPERTY
CAC CARD READ
CAC FILE DELETE
CAC FILE INIT
USER1
RETURN
EXECUTE
>>>
>>>
IRIS ADJUST >>>
>>>
>>>
SHADING SELECT
LENS SETUP
YES
NO
CHECK LUMINANCE LEVEL
PUSH SET
ZEBRA ON VF
SHADING: USER1 SET OK?