Operating Instructions

88
Mounting the Viewfinder and Adjusting its Position
Chapter 5 Preparation
Mounting the Viewfinder and Adjusting its
Position
This section shows how to mount and adjust the
supplied viewfinder and the optional AG-VF11G
viewfinder, which is equivalent to the supplied one.
When using a viewfinder other than these two
viewfinders, see the Operating Instructions provided
with that viewfinder.
• Note that old attachment models are not supported.
Mounting the Viewfinder
1
Confirm that the POWER switch is
turned off.
2
Connect the plug to the viewfinder
connector.
<Note>
Make sure that the plug is firmly seated in the
viewfinder connector.
3
Loosen the viewfinder right-left
positioning ring.
4
Turn the viewfinder securing screw
counterclockwise (to cancel the safety
mechanism) and slide the viewfinder in
the direction of the arrow.
5
Turn the viewfinder securing screw
clockwise (to prevent it from falling
off).
6
Tighten the viewfinder right-left
positioning rings.
<Note>
Be sure to firmly tighten the viewfinder securing screw
on the viewfinder right-left positioning module. The
viewfinder may fall off if the viewfinder securing screw
is not properly tightened.
Adjusting Viewfinder Right-
Left Position
1
Loosen the viewfinder right-left
positioning ring.
2
Slide the viewfinder right and left to
find a position that facilitates viewing.
3
Tighten the right and left viewfinder
positioning ring.
Loosen
Tighten
Viewfinder securing screw
Viewfinder right-left positioning ring