OWNERS MANUAL VCR AJ-SD965

19
Rear panel
< Fan
This fan is used to cool down the VTR.
If, for any reason, the fan stops, “E-10” will appear
on the counter display.
= SIGNAL GND terminal
This is connected to the signal ground terminal on
the component connected to this VTR in order to
minimize noise. It is not a safety ground.
> ANALOG COMPONENT VIDEO OUT connectors
The analog component video signals are output
through these connectors.
? ANALOG COMPOSITE VIDEO OUT connectors
The analog composite video signals are output
through these connectors.
The waveform monitor (WFM) signal can be output
from the VIDEO OUT 2 connector.
It can be selected using setup menu No. 00 (WFM
SEL).
Video signals containing superimposed information
can be output through the VIDEO OUT 3 connector.
Whether the superimposing is to be set ON or OFF
is selected using the SUPER switch 4 on the front
panel.
@ RS-232C connector
A personal computer or other component can be
connected to this connector to operate the VTR.
Parts and their functions
(continued)
A PARALLEL REMOTE connector
This connector is used when the VTR is to be
operated by an external component.
B ANALOG AUDIO OUT connectors
The analog audio signals are output through these
connectors.
C MONITOR OUT connectors
During playback, the PCM audio signals
(CH1/CH2/CH3/CH4) or playback signals from the
CUE track are output through these connectors.
<Note>
Noise may appear on the CUE signal at the instant
recording is started.
D OPTION connector
Use of an digital video interface board (AJ-
YAD955G, optional accessory) enables input/output
interfacing of the digital signals with the IEEE1394
standard.