Operating Instructions

26
Connections
When the total number of remote cameras and
switchers scheduled to be added has exceeded the
total number of units which can be registered (remote
cameras: 100 units; switchers: 1 unit), the [C/S OVER!]
message appears on the bottom line of the LCD panel.
Auto IP setting can still be initiated this state, but the IP
addresses will be set only for the number of units which
can be registered.
C:20/20 S:1/1
C/S OVER! YES
 Memo 
The camera numbers whose IP addresses have been
set using “Auto IP setting” will be set to “NetWork” for
their connection setting. Consequently, when “Auto IP
setting” is next initiated, these camera numbers will be
excluded from being targeted by the setting.
However, when the IP addresses of camera numbers
whose IP addresses were set using “Auto IP setting”
have been changed or the connection setting has been
changed to “NoAsign” or “Serial”, they will again be
targeted by “Auto IP setting”.
When the display for the number of units scheduled
to be added has dropped below the actual number
of units to be set because the power of the remote
cameras or the switcher has not been turned on for
some other reason, first remove the cause, and then
select “RETRY”, and press the F2 dial to initiate the IP
address settings again.
The number of units to be added can be updated.
C:20/20 S:1/1
RETRY
3 Turn the F2 dial, select “Yes,” and then press
the F2 dial.
This starts the “Auto IP setting” process.
 Memo 
p The numbers are set for the remote cameras in
sequence starting with the lowest number which was
set to “NoAsign” for the [CAM1] to [CAM100] item on
[CAMERA CTL] selected from the [SYSTEM] menu.
Similarly, the IP addresses which were set for the
camera numbers are set for the remote cameras.
The same subnet mask and default gateway settings
as the unit’s settings are selected.
p For the switcher, “NoAsign” is set for the [SW] item on
[SW CTL] selected from the [SYSTEM] menu.
The IP address which was set for the [IP:SW] item on
[SW IP ADR] selected from the [SYSTEM] menu is
selected for the switcher.
When “Auto IP setting” has been initiated, the progress
is shown by the number of displayed dots which are
reduced one by one.
SET UP IP
ttttt
When all the operations have been completed
successfully, “COMPLETE!” is displayed.
SET UP IP
COMPLETE!
The remote cameras and the switcher are automatically
rebooted, and they restart with the new IP addresses
which were set.
The remote cameras can now be operated from the unit.
The function for linking the switcher with the unit
becomes available for use at this point.
If the IP addresses were not set successfully, “SET UP
ERR!” is displayed.
SET UP IP
SET UP ERR!
This completes the settings for all the devices except for
the ones for which errors resulted.