Operation Manual

6
You will need the following additional items to install and configure the camera.
– a PC (see the system requirements in the Important Information document)
– 2 LAN cables (1 indoor cable and 1 outdoor cable)
– a router
 Safety Wire (1 pc.)
Order No. PQME10080Z
Used to secure the camera when wall
mounting it.
 Power Transfer Unit (1 pc.)
Order No. PNWP3C160A
Used to power the camera
 Flexible Stand (1 pc.)
Order No. PQKL10082Z1
Used to attach the camera to the wall
 Right-Angle Joint (1 pc.)
(with O-ring)
Order No. PNYCC160A
Used to protect the camera from
water
 Foam Strip (1pc.)
Order No. PQHG10748Z
Used to protect the camera from water
 Self Bonding Tape (1pc.)
Order No. PSHG1235Z
Used to protect the camera from
water
 Sensor Range Cap (1 pc.)
[BL-C160 Only]
Order No. PQHG10765Z
Used to limit the sensor detection range
 Setup CD-ROM (1 pc.)
Order No. PNQC1048Z
Contains the Setup Program needed
to configure the camera, as well as
the camera’s documentation.*
*See the included Important Information for a
description of each document.
 Important Information (1 pc.)
 Installation Guide (this
document) (1 pc.)
 Setup Guide (1 pc.)