CR_W402UA_001_cov.qxd 08.10.9 9:17 AM ページ2 Heavy Duty Weather Band Receiver LU APM P OW E R BAND PWR MUTE TUNE SEEK CLO SQ CR-W402UA CR-W402UA CR-W402U / PUSH SE ME L DIS P VO Model: 1 2 3 4 5 6 CK Operating Instructions ¡Please read these instructions (including “Limited Warranty” and “Customer Services Directory”) carefully before using this product and keep this manual for future reference.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ2 Safety Information ■ Read the operating instructions for the unit and all other components of your car audio system carefully before using the system. They contain instructions about how to use the system in a safe and effective manner. Panasonic assumes no responsibility for any problems resulting from failure to observe the instructions given in this manual.
CR_W402UA_01_eng.qxd 08.12.5 11:41 AM ページ3 ❑ Take care not to damage the leads. Caution Observe the following cautions when handling this unit. ❑ Keep the sound volume at an appropriate level. Keep the volume level low enough to be aware of road and traffic conditions while driving. ❑ This unit is designed for use exclusively in automobiles. ❑ Do not operate the unit for a prolonged period with the engine turned off.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ4 Customer Services Directory U.S.A. Customer Services Directory (United States and Puerto Rico) Obtain Product Information and Operating Assistance; locate your nearest Dealer or Servicenter; purchase Parts and Accessories; or make Customer Service and Literature requests by visiting our Web Site at: http://www.panasonic.com/support or, contact us via the web at: http://www.panasonic.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ5 Limited Warranty This warranty gives you specific legal rights and you may also have other rights which vary from state to state. If a problem with this product develops during or after the warranty period, you may contact your dealer or Servicenter. If the problem is not handled to your satisfaction, then write to warrantor’s Consumer Affairs Department at the addresses of the warrantor. U.S.A.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ6 Contents Safety Information (Part 15 of the FCC Rules) ................................................Page 2 Accessories .............................................................................................................3 Customer Services Directory ...................................................................................4 Limited Warranty .....................................................................................................
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ7 Power and Sound Controls Power Turn the key in the ignition until the accessory indicator lights. Power on: Press [PWR] (POWER). Power off: Hold down [PWR] (POWER) for more than 1 second. LU ME / PUSH SE APM P OW E R BAND R PW WR CR-W402UA CR-W402U L MUTE DIS P VO ACC ON TUNE SEEK CL SQ 1 2 3 4 5 OC K 6 Display Change Press [DISP] to switch to the clock display.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ8 LU ME / PUSH SE APM P OW E R BAND PWR CR-W402UA CR-W402U L MUTE DIS P VO Power and Sound Controls (Continued) TUNE SEEK CL SQ 1 2 3 4 5 6 OC K SQ (Sound Quality) SQ is a function that can call up various sound types at the touch of button in accordance with your listening music type. Press [SQ] for more than 2 seconds to select the sound type as follows: (FLAT) flat frequency response: does not emphasize any part.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ9 Note: If no operation takes place for more than 5 seconds in audio mode (2 seconds in volume mode), the display returns to the regular mode. Audio Modes (Bass/Treble/Balance/Fader) q Push [SEL] to select the audio mode. LU / PUSH SE ME P OW E R PWR CR-W402UA CR-W402U L MUTE SQ APM BAND DIS P VO Push TUNE SEEK CL 1 2 3 4 5 OC K 6 [VOLUME] clockwise or w Turn counterclockwise to change each level.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ10 Clock Adjustment Selecting the Clock Display Press [DISP] to change the display. Radio mode display (default) Clock display LU ME / PUSH SE APM P OW E R BAND PWR CR-W402UA CR-W402 L MUTE DIS P VO The 12-hour system is used for the clock. T UNE TUNE S EEK SEEK CL SQ 1 2 3 4 5 6 OC K [{TUNE] [}TUNE] (Hours, Minutes) Initial Time Time Readjustment q Press [DISP] (CLOCK). When you want to readjust the time, repeat steps w to y.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ11 Radio q Band Press [BAND] to change the band. FM1 FM2 AM 162 LU ME / PUSH SE APM P OW E R BAND PWR CR-W402UA CR-W402 L MUTE SQ DIS P VO (Weather Band) T UNE TUNE S EEK SEEK CL 1 2 3 4 5 6 OC K FM stereo indicator, lights while receiving an FM stereo signal. w Manual Tuning [}TUNE]: Higher frequency [{TUNE]: Lower frequency Seek Tuning Press and hold for more than 0.5 seconds and release it.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ12 Radio (Continued) Preset Station Setting Up to 6 stations can be saved in each of the FM1, FM2 and AM preset station memories. Note: Existing saved stations are overwritten with new stations after following this procedure. q Band LU ME / PUSH SE P OW E R PWR CR-W402UA CR-W402 L MUTE SQ APM B AND BAND TUNE SEEK 1 2 3 4 5 DIS P VO Press [BAND] (APM) to select a desired band.
LU ME P OW E R PWR CR-W402UA CR-W402 / PUSH SE L MUTE SQ APM BAND DIS P VO CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ13 TUNE SEEK CL 1 2 3 4 5 6 OC K Tuning in a Weather Band Station • Press [BAND] (APM) to select WB (Weather Band). (a page 11) • Press any of the buttons [1] to [6] to monitor the preset station. WB Weather Band Frequency (channel) Number Note: The weather band (CH1-6) has been preset. CH7 is selected by pressing [{] or [}].
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ14 Troubleshooting If You Suspect Something Wrong Check and take steps as described below. If the described suggestions do not solve the problem, it is recommended to take the unit to your nearest authorized Panasonic Servicenter. The product should be serviced only by qualified personnel. Please refer the checking and the repair to professionals.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ15 ■ Sound Setting Problem No sound from left, right, front, or rear speaker. Left and right sounds are reversed in stereo listening. Possible cause a Possible solution Left and right balance, or front and rear balance is off on one side. aAdjust BAL/FAD as appropriate. Cables are not correctly connected. aConnect the cables correctly. The right speaker wire is connected to the left speaker and the left speaker wire to the right speaker.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ16 Maintenance Care of the Unit ❐ Cleaning this Unit ❐ Caution on Cleaning Use a dry, soft cloth to wipe. Never use solvents such as benzine, thinner as they may mar the surface of the unit. Your product is designed and manufactured to ensure the minimum of maintenance. Use a soft cloth for routine exterior cleaning. Never use benzine, thinner, or other solvents. Warning Use fuses of the same specified rating (15 A).
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ17 Installation Guide WARNING ❐ This installation information is designed for experienced installers and is not intended for non-technical individuals. It does not contain warnings or cautions of potential dangers involved in attempting to install this product. Any attempt to install this product in a vehicle by anyone other than a qualified installer could cause damage to the electrical system and could result in serious personal injury or death.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ18 Installation (continued) ❏ Precautions ❐ Installation Hardware Warning If your vehicle is equipped with air bag and/or anti-theft systems, specific procedures may be required for connection and disconnection of the battery to install this product. Before attempting installation of this electronic component, contact your vehicle dealer or manufacturer to determine the required procedure and strictly follow their instructions.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ19 Caution ¡We strongly recommend that you wear gloves for installation work to protect yourself from injuries. ¡When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your hands and fingers. First complete the electrical connections, and then check them for correctness.(a page 20) The included Mounting Collar q is designed specially for this unit. Do not use it to attach any other model.
CR_W402UA_01_eng.qxd 08.10.9 9:14 AM ページ20 Electrical Connections Caution • This wiring information is for experienced technical individual, for safety reason, please your dealer wire this connection. • This product is designed to operate with a 12 V DC, negative ground battery system. • To prevent damage to the unit, be sure to follow the connection diagram below. • Do not insert the power connector into the unit until the wiring is completed.
CR_W402UA_01_eng.qxd 08.12.5 11:41 AM ページ21 Specifications ❐ General Power Supply: Current consumption: Maximum Power Output: Tone adjustment range: Bass: Treble: Power Output: Suitable Speaker Impedance: Dimensions (W × H × D): Weight: 12 V DC (11 V-16 V) test Voltage 14.4 V, Negative @ ground Less than 2.5 A (0.
CR_W402UA_01_eng.qxd 08.10.
CR_W402UA_01_eng.qxd 08.10.
CR_W402UA_001_cov.qxd 08.10.