Operating Instructions

6
To select operation mode
AUTO mode - For your convenience
• During operation mode selection the power
indicator blinks.
• Unit selects operation mode every 10 minutes
according to setting temperature and room
temperature.
Single
• Unit selects operation mode every
10 minutes according to setting
temperature and room temperature.
Multi
• Unit selects operation mode every 3
hours according to setting temperature,
outdoor temperature and room
temperature.
HEAT mode - To enjoy warm air
• Unit takes a while to warm up. The power
indicator blinks during this operation.
COOL mode - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
To switch between
powerful & quiet
QUIETPOWERFUL NORMAL
POWERFUL: To reach temperature quickly
POWERFUL
Single
• This operation stops automatically after
20 minutes.
Multi
• Press the button again or turn OFF the
unit to stop this operation.
QUIET: To enjoy quiet operation
QUIET
• This operation reduces airfl ow noise.
How to use
Remote control receiver
and indicator
POWER
(Green)
TIMER
(Orange)
POWERFUL
(Orange)
QUIET
(Orange)
To select fan speed
(Remote control display)
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
• To have low noise priority operation, select the
lowest fan speed ( ).
Auto OFF/ON button
Use when remote control is misplaced or a malfunction occurs. Raise the front panel:
• To use in AUTO mode, press the button once.
• To use in COOL mode, press and hold the button until 1 beep is heard, then release.
• To use in HEAT mode, press and hold the button until 1 beep is heard, then release.
And press again until 2 beeps, then release.
• Press the button again to turn off.
Remote control
display
Press to restore the
remote control to
default setting.
Press and hold for
approximately
10 seconds to show
temperature setting in
°C or °F.
Not used in normal
operations.
Single
Single split system
Multi
Multi split system