Operation Manual

- 81 -
Recording
• The flash setting may change if the Recording Mode is changed. Set the flash setting again if
necessary.
• The flash setting is memorised even if the camera is turned off. When changing scene using
Scene Guide Mode, the Scene Guide Mode flash setting is returned to the default value with
each change of scene.
• Flash will not be activated when recording motion picture.
∫ The available flash range
If the distance to the subject is close when taking a picture using a flash, part of the
recorded image becomes dark because the light of flash is blocked by the lens or it
becomes out of flash range. Check the distance to the subject when taking a picture. The
distance at which light from the flash is blocked by lens, and the distance to which light
from the flash is delivered vary depending on the lens used.
•
The available flash range is an approximation.
• This is the range when [ISO Limit Set] (P144) is set to [OFF].
When the interchangeable lens (H-PS14042) is used
Available flash range
Wide Tele
[AUTO] in [Sensitivity]
30 cm (0.99 feet) to 5.7 m
(18.8 feet)
30 cm (0.99 feet) to 3.5 m
(11.5 feet)
When the
interchangeable
lens (H-H014) is
used
When the interchangeable lens (H-FS014042) is used
Available flash range according to focal length of lens
(When the aspect ratio is [X].)
Available flash
range
Wide to 17 mm 18 mm Tele
[AUTO] in
[Sensitivity]
50 cm (1.65 feet)
to 8.0 m
(26.3 feet)
Vignetting effect
occurs due to the
light of the flash.
1.0m (3.29feet)
to 4.9 m
(16.1 feet)
40 cm (1.32 feet)
to 3.5 m
(11.5 feet)