Operation Manual

VQT3A48

Before Use

There are 2 ways to operate the rear dial, rotating left or right, and deciding by pressing.

Rotating:

Selection of items or setting of values is performed during the various settings.

Pressing:

Operations that are the same as [MENU/SET] button, such as selection of settings

and exiting the menu, are performed during the various settings.

•

Rear dial is described as follows in these operating instructions.

At the time of purchase, [INTELLIGENT AUTO] is assigned to the

[Fn1] button, [FILM MODE] to the 2 (Fn2) button and

[METERING MODE] to the 4 (Fn3) button.

•

The functions to be assigned can be selected from the menu below

using [Fn BUTTON SET] in the [CUSTOM] menu.

Note

•

Refer to P118 for details about [REC] Mode menu.

• Refer to P130 for details about [CUSTOM] menu.

• When [INTELLIGENT AUTO] is set, pushing the button will switch to Intelligent Auto Mode.

(Pressing the button again or turning off the camera will cancel the setting.)

• When set to [FOCUS AREA SET], it is possible to display the position setting screen of either

AF area or MF Assist.

• When [1 SHOT ] is set, it will record the RAW file and a fine JPEG image simultaneously

once only. It will return to original quality after recording.

• When [1 SHOT Ù] is set, it will record with [METERING MODE] set to [Ù] (spot) once only. It

will return to original Metering Mode after recording.

Rear Dial

e.g.: Rotating left or right e.g.: Pressing the rear dial

Function button

[REC] menu/Recording functions

[CUSTOM] menu

[INTELLIGENT AUTO]/[FILM MODE]/

[FOCUS AREA SET]/[ASPECT RATIO]/[QUALITY]/

[1 SHOT ]/[METERING MODE]/[1 SHOT Ù]/

[FLASH]/[FLASH ADJUST.]/[ISO LIMIT SET]/

[EX. TELE CONV.]/[BURST RATE]/

[AUTO BRACKET]

[GUIDE LINE]/[SHUTTER AF]/

[PRE AF]/[ REC AREA]

DMC-GH2H&GH2K&GH2EB-VQT3A48_eng.book 18 ページ２０１０年１０月１４日　木曜日　午後３時５０分