Operation Manual

27
VQT3A48
Preparation
Recording conditions by CIPA standard
CIPA is an abbreviation of [Camera & Imaging Products Association].
Temperature: 23 oC (73.4 oF)/Humidity: 50%RH when LCD monitor is on.
Using a Panasonic SD Memory Card (2 GB).
Using the supplied battery.
Starting recording 30 seconds after the camera is turned on.
Recording once every 30 seconds with full flash every second recording.
Turning the camera off every 10 recordings and leaving it until the temperature of the battery
decreases.
The number of recordable pictures varies depending on the recording interval time.
If the recording interval time becomes longer, the number of recordable pictures
decreases. [For example, if you were to take one picture every two minutes, then the
number of pictures would be reduced to approximately one-quarter of the number
of pictures given above (based upon one picture taken every 30 seconds).]
Playback (when using the LCD monitor)
Note
The operating times and number of recordable pictures will differ according to the
environment and the operating conditions.
For example, in the following cases, the operating times shorten and the number of recordable
pictures is reduced.
In low-temperature environments, such as on ski slopes.
Using the [AUTO] of [LCD MODE] or [MODE1] of [LCD MODE] (P59).
When flash is used repeatedly.
When the operating time of the camera becomes extremely short even after properly charging
the battery, the life of the battery may have expired. Buy a new battery.
When the 14140 mm/F4.05.8 lens supplied in
DMC-GH2H is used
Playback time Approx. 240 min
When the 1442 mm/F3.5 5.6 lens supplied in
DMC-GH2K is used
Playback time Approx. 250 min
VQT3A48~Body1_mst.fm 27 ページ 2010年10月15日 金曜日 午後1時38分