Digital Camera Operating Instructions

Others
90
VQT1X05
[MEMORY CARD ERROR FORMAT THIS CARD?]
• This card has a format which is not recognized by the camera.

Format the card again with the camera after saving necessary data on a PC etc. (P24)
[PLEASE TURN CAMERA OFF AND THEN ON AGAIN]/[SYSTEM ERROR]
• This message appears when the camera is not operating properly.

Turn the camera off and on. If the message persists, contact the dealer or your
nearest Service Center.
[MEMORY CARD PARAMETER ERROR]

Use a card compatible with this camera. (P15)
• You can only use an SDHC Memory Card if using cards with 4GB or more capacity.
[MEMORY CARD ERROR PLEASE CHECK THE CARD]
• Failed access to the card.

Insert the card again.

Insert a different card.
[READ ERROR PLEASE CHECK THE CARD]/
[WRITE ERROR PLEASE CHECK THE CARD]
• It has failed to read or write data.

Turn the camera off and remove the card. Insert the card again, turn the power on,
and try to read or write the data again.
• The card may be broken.

Insert a different card.
[MOTION RECORDING WAS CANCELLED DUE TO THE LIMITATION OF THE
WRITING SPEED OF THE CARD]
• When you set the picture quality to [WVGA] or [VGA], we recommend using a high-
speed card with “10MB/s” or greater displayed on the package.
• If the operation stops even if you use the card with memory size of 10MB/s or greater,
this means the data-writing speed become lowered. We recommend backing up the data
and formatting the card. (P24)
• Depending on the type of SD Memory Card or SDHC Memory Card, motion picture
recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
• A folder cannot be created because there are no remaining folder numbers that can be
used. (P76)

Format the card after saving necessary data on a PC etc. (P24)
[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
• The AV cable is connected to the camera.

Press [MENU/SET] if you want to delete this message at once.

Select [TV ASPECT] in the [SETUP] menu to change the TV aspect. (P23)
• This message also appears when the USB connection cable is connected to the camera
only. In this case, connect the other end of the USB connection cable to a PC or a
printer. (P75, 77)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
• The printer cannot print.

Check the printer.
VQT1X05_DMC-LS85_P-PC_EN.indb 90VQT1X05_DMC-LS85_P-PC_EN.indb 90 2008/12/22 20:20:342008/12/22 20:20:34