Operation Manual

205
SQW0550
Shutter and Drive Settings
Burst function
●
When the burst speed is set to [H] and if many burst pictures are taken, the burst speed may be
reduced while burst pictures are being taken.
●
When the burst speed is set to [SH] or [H] ([AFS/AFF/AFC] in [Rec] menu is set to [AFS] or the
focus mode is set to [MF]), and the exposure and White Balance are fixed to those of the first
picture.
When the burst speed is set to [H] ([AFS/AFF/AFC] in [Rec] menu is set to [AFF] or [AFC]), [M], or
[L], and the exposure and White Balance are adjusted individually for each still picture.
●
Burst speed may be reduced if shutter speed (pictures/sec.) is reduced in darker locations.
●
With repeated recordings, it may take a while between recordings, depending on the usage
conditions.
●
It may take a while to store still pictures that were taken using the burst function. If you
continue to record while storing, the number of burst pictures that can be taken will be
reduced. A high-speed card is recommended when recording using the burst function.
●
This function is not available in the following cases:
• [Glistening Water], [Glittering Illuminations], [Handheld Night Shot], [Soft Image of a Flower]
(Scene Guide Mode)
• [Rough Monochrome], [Silky Monochrome], [Miniature Effect], [Soft Focus], [Star Filter],
[Sunshine] (Creative Control Mode)
• When using [Time Lapse Shot]
• When [Auto Shooting] of [Stop Motion Animation] is set to [ON]
• When recording using [Post Focus]
• During motion picture recording
• When recording using the flash
•
TZ100/TZ101
During T (Time) recording
•
TZ100/TZ101
When [Multi Exp.] is set
●
[SH] in Burst Mode cannot be used In the following cases:
• When [Quality] is set to [
], [ ] or [ ]
• When using [Stop Motion Animation]