Manual

GB
10
English
If the status lamp blinks or glows
Follow the steps outlined below if the status lamp blinks or
glows during the “Clean/Dry/Charge” course or the “Clean/Dry”
course.
Blinks Glows
Correctly set the
detergent cartridge
and then restart a
course.
Remove the shaver from the self-
cleaning recharger and then check
that the [CLEAN] lamp has gone
out. (Be careful as the blade may
be hot or wet.) Check that the
water tank is correctly attached,
the water tank cap is securely
closed and the self-cleaning
recharger is placed horizontally.
If the status lamp
goes out
Continue a course.
When an abnormality
has been corrected
When no abnormality was found
Press and hold
[SELECT] for 2
seconds to turn off the
status lamp and then
restart a course.
It is time to replace the detergent
cartridge and cleaning liquid
inside the water tank.
Wash away the old cleaning
liquid and then rise the water
tank. Restart the course.
When the status lamp
goes out
When the status lamp glows
again
Continue a course. Contact an authorized service
center.

Cleaning the shaver without the self-cleaning
recharger
We recommend that you clean your
shaver with the self-cleaning recharger or
the “sonic” vibration turbo-cleaning mode
when the faucet symbol appears on
the LCD panel.
1. Disconnect the power cord from the
shaver.
2. Apply some hand soap and some
water to the outer foil.
3. Press the OFF/ON switch for more
than 2 seconds to activate the turbo
mode for “sonic” vibration cleaning.
appears on the LCD panel.
After about 20 seconds, it will be
automatically turned off, or you can
turn it off by pressing the OFF/ON
switch.
4. Remove the system outer foil.
5. Press the OFF/ON switch for more
than 2 seconds to activate the turbo
mode and clean it with running water.
6. Wipe off any drops of water with a dry
cloth.
7. Remove the system outer foil to allow it
to dry completely.
•
•
3
4
5
Cleaning with the brush
1. Press the system outer foil release buttons and lift the
system outer foil upwards.