Operation Manual

VQT2N35

Message is displayed when this unit is moved rapidly.

≥ Change the mode to .

When “CAMERA PANNING IS TOO FAST.” appears, move the unit slowly while recording.

≥ Message will not appear while pausing the recording. (Message will appear even if it is

pausing the recording if [DEMO MODE] is set to [ON])

≥ In some recording conditions, messages may not appear.

This will reduce the wind noise coming into the built-in microphones while maintaining the

realism.

≥ Change the mode to .

≥ Switch to manual mode. (l 69)

≥ When switching to intelligent auto mode, [WIND NOISE CANCELLER] is set to [ON], and

the setting cannot be changed.

≥ You may not see the full effect depending on the recording conditions.

Directivity of the microphone is interlocked with the zoom operation. Sounds near the front of

the unit are recorded more clearly if you zoom in (close-up) and surrounding sounds are

recorded more realistically if you zoom out (wide angle).

≥ Change the mode to .

≥ Switch to manual mode. (l 69)

[SHOOTING GUIDE]

: [RECORD SETUP] # [SHOOTING GUIDE] # [ON]

[WIND NOISE CANCELLER]

: [RECORD SETUP] # [WIND NOISE CANCELLER] # [ON]

[ZOOM MIC]

: [RECORD SETUP] # [ZOOM MIC] # [ON]