Manual

Theunitisputintorecordingpauseapprox.1secondwhenthepoweristurnedonwiththe

modesetto _ orO.

• Dependingontherecordingconditions,starttimemaybelongerthan1secondinStill

PictureRecordingMode.

• IntheQuickpoweronmode,thezoommagnificationbecomes1×.

Thisunitisputintorecordingpauseapprox.0.6secondsaftertheLCDmonitorisreopened.

• When in Quick start standby mode about 80% of the power used in Recording pause

mode is being consumed, so the recording time will be reduced,

• Start time will not shorten if there is no SD card inserted.

Start time will be shortened if the [Built-inMemory] is selected in the [MEDIA SELECT],

even if there is no SD card inserted.

Start time will be shortened if the [HDD] is selected in the [MEDIA SELECT], even if there

is no SD card inserted.

• Change the mode to _ or O.

1 Set [QUICK START] to [ON].

2 Close the LCD monitor while the mode is set

to _ or _. O

The status indicator O flashes green and the unit goes

into Quick start standby mode.

• The lens cover does not close.

3 Open the LCD monitor.

The status indicator O lights red and the unit is put into

recording pause.

• Quick start standby mode is canceled if

about 5 minutes have elapsed

mode is set to []

• Depending on the recording conditions, time for Quick Start may be more than 0.6 seconds

slower in Still Picture Recording Mode.

• It may take some time for Automatic white balance to adjust.

• In the Quick Start Mode, the zoom magnification becomes 1×.

• If [ECONOMY] (-) 45) is set to [5 MINUTES] and the unit automatically goes into Quick

Start Standby Mode, close the LCD monitor and then open it again.

• Turn the unit off using the power button.

VQT2M51