Operation Manual

122
VQT2U82
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥ Remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC
adaptor. Then about 1 minute later, turn on the unit
again. (Conducting the above operation while the
media is being accessed may damage the data on
the media.)
≥ If normal operation is still not restored, detach the
power connected, and consult the dealer who you
purchased this unit from.
Item other than the
touched one is
selected.
≥ Calibrate the touch screen. (l 40)
The remote control
does not function.
≥ [REMOTE CONTROL] of the [SETUP] is [OFF].
(l 42)
≥ The button-type battery of the remote control may be
run out. Replace it with a new button-type battery.
(l 42)
The remaining time
indication or the
elapsed time
indication is not
shown.
≥ [DISPLAY] of the [SETUP] is [OFF]. (l 35)
The unit arbitrarily
stops recording.
≥ Use an SD card that can be used for motion picture
recording. (l 17)
≥ The recordable time may have shortened due to the
deterioration of the data writing speed or repeated
recording and deletion. Using the unit, format the SD
card. (l 40)
≥ If [AGS] is [ON], record in the normal horizontal
position or set [AGS] to [OFF]. (l 61)
Auto focus function
does not work.
≥ Switch to intelligent auto mode.
≥ If you are trying to record a scene which is hard to
bring into focus in auto focus mode, use the manual
focus mode to adjust the focus. (l 29, 74)
HDC-SD600EB-VQT2U82_mst.book 122 ページ ２０１０年４月１５日 木曜日 午後３時２分