Operation Manual

22
VQT2U82
Preparation
Setup
6
Setting date and time
When the unit is turned on for the first time, a message asking you to set the date and time
will appear.
Select [YES] and perform steps 2 to 3 below to set the date and time.
¬ Change the mode to or .
1 Select the menu.
2 Touch the date or time to be
set, then set the desired value
using / .
A Displaying the World time setting
(l 35):
[HOME]/ [DESTINATION]
≥ The year can be set between 2000 and
2039.
≥ The 24-hour system is used to display the
time.
3 Touch [ENTER].
≥ The clock function starts at [00] seconds.
≥ A message prompting for World time
setting may be displayed. Perform the
World time setting by touching the screen.
(l 35)
≥ Touch [EXIT] or press the MENU button to
complete the setting.
≥ The date and time function is driven by a
built-in lithium battery.
≥ When this unit is purchased, the clock is
set. If the time display becomes [- -], the
built-in lithium battery needs to be
charged. To recharge the built-in lithium
battery, connect the AC adaptor or attach
the battery to this unit. Leave the unit as it
is for approx. 24 hours and the battery will
maintain the date and time for approx.
6 months. (The battery is still being
recharged even if the unit is off.)
: [SETUP] # [CLOCK SET]
WARNING
THE LITHIUM BATTERY IN THIS
EQUIPMENT MUST ONLY BE
REPLACED BY QUALIFIED
PERSONNEL. WHEN NECESSARY,
CONTACT YOUR LOCAL PANASONIC
SUPPLIER.
HDC-SD600EB-VQT2U82_mst.book 22 ページ ２０１０年４月１５日 木曜日 午後３時２分