APPENDIX D INSTALLATION INSTRUCTIONS CZ-RD515U (852-6-4190-592-00-0) A-4
INSTALLATION INSTRUCTIONS Wired Remote Controller IMPORTANT In order to install this wired remote controller onto a wall-mounted model, the connection kit (CZ-RC515U or CZ-RC515UA), which must be purchased separately, is required. Once the wired remote controller is connected, the wireless remote controller cannot be used. Parts supplied with the remote controller See Table 1. Remote controller installation guidelines Installation location Mount the remote controller 3.3 to 4.9 ft. (1 to 1.
B. Installing directly onto the wall (1) Insert a flathead screwdriver into the 5 tab locations and disconnect the back plate of the remote controller by lifting up slightly. (Fig. 2-b) The tabs are thin; take care not to chip them. (2) Use tapping screws to directly fasten the remote controller back plate onto the wall. (Fig. 6) (3) Insert the connector into the PCB of the remote controller unit, and wrap the wire harness around the hook. (Fig.
How to wire the remote controller Ceiling panel (1) Turn OFF the power and remove the ceiling panel air-intake grille. (Refer to 3-6-1 Before Installing the Ceiling Panel in the Installation Instructions supplied with the indoor unit.) (2) Remove the 3 power box cover screws and 2 control box cover screws, then remove both covers. At this time, take care not to drop the covers. (Fig.
How to Test Run the Air Conditioner After turning on the power of the air conditioner, use the remote controller and follow the steps below to conduct the test run. (1) Set the remote controller in Test Run mode. (Fig. 9) a)Press and hold the NIGHT SETBACK button and the 1HR. TIMER button. ON/OFF operation button b)Then press and hold the ACL (Reset) button with a pointed object such as the tip of a pen. After 5 seconds, release the ACL button first.
DC1111-0