Operating instructions

1. Introduction and Installation
19
3 Before loading a stack of paper, fan the
paper to prevent paper jams.
4 Load the paper, print-side up (1).
Important:
L Push and lock the plate (2) in the
paper input tray, if it is lifted.
5 Adjust the width to the size of the recording
paper by sliding the front side of the guide
(1).
L Make sure that the recording paper is
under the paper limit mark (2), and the
paper should not be over the snubbers
(3).
6 Close the paper input tray.
Note:
L If the paper is not loaded correctly, re-adjust
the paper guides, or the paper may jam.
L If the paper input tray does not close, the
plate in the paper input tray may be lifted.
Push the paper and check that the paper is
flat in the paper input tray.
To pull the paper input tray completely out
Pull the paper input tray (1) until it clicks into
place, then pull it completely out, lifting the front
part of the tray.
L To insert the paper input tray
Insert the paper input tray (1) to the unit,
lifting the front part of the tray. Then push it
completely into the unit.
1
2
1
2
3
3
1
1
FLB851E-PFQX2329ZA-en.book Page 19 Friday, December 16, 2005 3:12 PM