Operating instructions

3. Fax
29
3FaxSen ding Faxes
3.1 Using the unit as a fax
machine
3.1.1 Entering the fax mode
Before sending a fax, set the operation mode to
the fax mode.
Press {FAX} to turn the {FAX} light ON.
Note:
L You can change the default operation mode
(feature #463 on page 64) and the timer
before returning to the default operation
mode (feature #464 on page 64).
L Received documents will be stacked on the
lower output tray. You can change the output
tray for faxing (feature #441 on page 68).
3.2 Sending a fax manually
3.2.1 Using the auto document
feeder
L Confirm that there are no documents on
the scanner glass.
1 If the {FAX} light is OFF, turn it ON by
pressing {FAX}.
2 Adjust the width of the document guides (1)
to fit the actual size of the document.
3 Insert the document (up to 50 pages) FACE
UP into the feeder until a single beep is
heard.
L If the document guides are not adjusted
to fit the document, re-adjust them.
4 If necessary, change the following settings
according to the type of document.
L To select the resolution, see page 29.
L To select the contrast, see page 29.
5 Press {MONITOR}.
6 Dial the fax number.
7 Press {START}.
Note:
L Any document which can be sent as a fax can
also be copied and scanned (page 31).
L Do not open the document cover when
sending a fax with the auto document feeder.
To stop sending
Press {STOP}.
To select the resolution
1. Press {RESOLUTION}.
2. Press {V} or {^} repeatedly to select the
desired resolution.
– “STANDARD”: For printed or typewritten
documents with normal-sized characters.
– “FINE”: For documents with small print.
– “SUPER FINE”: For documents with very
small print. This setting is effective only
when the other party has a compatible fax
machines.
– “PHOTO”: For documents containing
photographs, shaded drawings, etc.
L Using the “FINE”, “SUPER FINE” and
“PHOTO” settings will increase transmission
time.
L If the resolution setting is changed during
feeding, it will be effective from the next page.
To select the contrast
You can adjust this setting depending on the
lightness or darkness of the document. 5 levels
(light to dark) are available.
1. Press {CONTRAST}.
2. Press {V} or {^} repeatedly to select the
desired contrast.
{FAX}
{CONTRAST}
{FAX}
{STOP}
{RESOLUTION}
{START}
{SET}{V}{^}
{REDIAL}
{MONITOR}
1
{QUICK SCAN}
FLB851E-PFQX2329ZA-en.book Page 29 Friday, December 16, 2005 3:12 PM