Operating instructions

7. Programmable Features
66
{#}{4}{1}{1} Sending documents overseas
OVERSEAS MODE
=ERROR [V^]
If you cannot send a fax overseas even if the
number is correct and the line is connected,
activate this feature before sending the fax.
This feature improves the reliability by reducing
the transmission speed.
{0} “OFF”: Deactivates this feature.
{1} “NEXT FAX”: This setting is effective only for
the next attempted fax transmission. After
transmission, the unit will return to the previous
setting.
{2} “ERROR” (default): When the previous fax
transmission fails and you wish to re-send the
document.
Note:
L This feature is not available for broadcast
transmission.
L Calling charges may be higher than usual.
{#}{4}{1}{2} Sending a fax at a specific time
DELAYED SEND
MODE=OFF [V^]
This feature allows you to take advantage of low-
cost calling hours offered by your telephone
company. This feature can be set up to 24 hours
in advance of the desired time.
{0} “OFF” (default)
{1} “ON”
To send a document:
1. Insert the document into the auto document
feeder.
2. If necessary, change to the desired resolution
(page 29) and the desired contrast (page 29).
3. Press {MENU}.
4. Press {#}, then {4}{1}{2}.
5. Press {1} to select “ON”.
6. Press {SET}.
7. Enter the fax number.
L To enter an item using one-touch dial
feature and navigator directory, see step 4
on page 34. (When using navigator
directory, you do not have to press
{DIRECTORY} before pressing {V} or
{^}.)
8. Press {SET}.
9. Enter the transmission start time.
L Press {*} repeatedly to select “AM” or
“PM”.
10.Press {SET}.
L The document will be fed into the unit and
scanned into memory. The unit will then
send the data at the specified time.
Note:
L To cancel after programming, press {STOP}
then {SET}.
L You can also send a document using the
scanner glass. Press {SET} in step 10, then
press {START}.
{#}{4}{1}{3} Setting the Error Correction
Mode (ECM)
ECM SELECTION
MODE=ON [V^]
This feature is available when the sending /
receiving fax machines are ECM compatible.
{0} “OFF”: Deactivates this feature.
{1} “ON” (default): If there is an error during fax
transmission / reception, the unit will support the
communication.
{#}{4}{1}{6} Setting the connecting tone
CONNECTING TONE
MODE=ON [V^]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones:
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party’s machine.
{0} “OFF”: Deactivates this feature.
{1} “ON” (default): You will hear connecting
tones.
Note:
L If the ring back tone continues, the other
party’s machine may not be a fax machine or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
{#}{4}{3}{2} Receiving other size
documents
AUTO REDUCTION
MODE=ON [V^]
To receive a fax document that is longer than
your recording paper.
{0} “OFF”: The unit will print the original size.
{1} “ON” (default): The unit will fit received
documents onto your recording paper.
{#}{4}{3}{4} Changing the fax activation
code
FAX ACTIVATION
MODE=ON [V^]
FLB851E-PFQX2329ZA-en.book Page 66 Friday, December 16, 2005 3:12 PM