Operating instructions

7. Programmable Features
67
If you wish to use an extension telephone to
receive faxes, activate this feature and program
the activation code.
{0} “OFF”
{1} “ON” (default)
1. Press {MENU}.
2. Press {#}, then {4}{3}{4}.
3. Press {1} to select “ON”.
4. Press {SET}.
5. Enter your code from 2 to 4 digits, using 0–9,
{*} and {#}.
L The default code is “;#9”.
L Do not enter “0000”.
6. Press {SET}.
7. Press {MENU}.
{#}{4}{3}{5} Setting the auto disconnection
AUTO DISCONNECT
MODE=ON [V^]
To answer a call with an extension telephone in
TEL/FAX mode (page 38), activate this feature
and program the code.
{0} “OFF”
{1} “ON” (default)
1. Press {MENU}.
2. Press {#}, then {4}{3}{5}.
3. Press {1} to select “ON”.
4. Press {SET}.
5. Enter your code from 2 to 4 digits, using 0–9
and {*}.
L The default code is “;0”.
6. Press {SET}.
7. Press {MENU}.
{#}{4}{3}{6} Changing the silent fax
recognition ring setting
SILENT FAX RING
RINGS=3 [V^]
To change the number of times the unit rings
while in TEL/FAX mode.
{3} “3” (default)
{4} “4”
{5} “5”
{6} “6”
{7} “7”
{8} “8”
{9} “9”
Note:
L See page 38 for details.
{#}{4}{3}{7} Setting the memory reception
alert
RECEIVE ALERT
MODE=ON [V^]
To alert you with a beeping sound when a
received fax document is stored into memory
due to some existing problem.
The slow beeps will continue until you clear the
printing problem and make sure the unit is
supplied with enough paper to print the stored
document.
{0} “OFF”: Deactivates this feature.
{1} “ON” (default): You will be alerted to a
reception problem by a beeping sound.
{#}{4}{3}{8} Setting friendly reception
FRIENDLY RCV
MODE=ON [V^]
To receive a fax automatically when you answer
a call and hear a fax calling tone (slow beep).
{0} “OFF”: You have to press {START} for fax
reception.
{1} “ON” (default): You do not have to press
{START} for fax reception.
{#}{4}{4}{0} Setting the input tray to use for
faxing
FAX INPUT TRAY
=#1 [V^]
You can select the input tray that will be used for
printing received faxes.
{1} “#1” (default): Paper input tray
{2} “#2”: Multi-purpose input tray
L When the optional input tray is installed, the
following will be displayed.
{1}: “#1”
{2}: “#2”
{3}: “#3”
{4}: “#1+#3” (default)
Note:
L Lists or reports printed by pressing { HELP}
(page 24) or {MENU} (page 93) will be fed
from the paper input tray.
L When the input tray setting is set to “#1+#3”,
the paper size in the paper input tray (feature
#380 on page 64) and the optional input tray
(feature #382 on page 64) should be the
same. If either of the paper size is changed,
the input tray setting will be changed to “#1”
automatically.
FLB851E-PFQX2329ZA-en.book Page 67 Friday, December 16, 2005 3:12 PM