Operating instructions

8. Help
75
Troubleshooting
8.3 When a function does not work, check here
8.3.1 Initial settings
8.3.2 General
Problem Cause & Solution
I cannot hear a dial tone. L The telephone line cord is connected to the [EXT] socket on the
unit. Connect to the [LINE] socket (page 22).
L If you use a splitter/coupler to connect the unit, remove the
splitter/coupler and connect the unit to the wall socket directly. If
the unit operates properly, check the splitter/coupler.
L Disconnect the unit from the telephone line and connect a known
working telephone. If the working telephone operates properly,
contact our service personnel to have the unit repaired. If the
working telephone does not operate properly, contact your
telephone company.
L The mains lead or telephone line cord is not connected. Check the
connections.
L If you connected the unit through a computer modem, connect the
unit directly to a telephone line socket.
The unit does not ring. L The ringer volume is turned OFF. Adjust it (page 24).
Problem Cause & Solution
The other party complains
they only hear a fax tone
and cannot talk.
L FAX ONLY mode is set. Tell the other party the number is only used
for faxes.
The {PAUSE} button does
not function properly.
L If this button is pressed during dialling, a pause will be inserted. If
pressed immediately after a dial tone is obtained, the last number
dialled will be redialled.
During programming, I
cannot enter the code or
ID number.
L All or part of the number is the same. Change the number: feature
#322 (page 63), #434 (page 66) and #435 (page 67).
The unit beeps. L The memory reception alert of feature #437 is ON (page 67), and
the unit has a document in memory. Press {STOP} to stop the
beeps, then see the displayed message instructions to solve the
problem.
The output tray becomes
full quickly or the
recording paper does not
stack properly on the
output tray.
L High humidity may cause the recording paper to curl. Try turning
the paper over and re-inserting it. If the curl on the paper is heavy,
please remove it from the output tray. If you still have this problem,
contact our service personnel.
I cannot operate the help
function, adjust volumes
or program the features.
L The unit is set to the scan mode. Press {COPY} or {FAX} to switch
to the copy mode or fax mode. If you still have this problem, contact
our service personnel.
FLB851E-PFQX2329ZA-en.book Page 75 Friday, December 16, 2005 3:12 PM