User Guide

Others
120
VQT0X92
Using the Remote
Shutter
If you use the remote shutter (DMW-RSL1;
optional), you can avoid jitter (camera
shake) when using a tripod. The remote
shutter works similar to the shutter button
on the camera.
1 Connect the remote shutter to
the [REMOTE] socket on the
camera firmly.
2 Take a picture.
1:Press the button lightly to press
halfway.
2:
Press the button fully to take the
picture. (Press it as far as it will go.)
∫ About [LOCK] on the remote shutter
• You can keep the shutter button
pressed fully.
• While pressing the shutter button fully,
slide it to the [LOCK] side.
• Slide it to the other side to cancel
[LOCK].
• Cancel [LOCK] on the remote shutter
before connecting it to the camera.
• The camera cannot be operated while the
shutter button on the remote shutter is
held down or while the shutter button is at
the [LOCK] position.
• Bulb exposure is not available with this
camera.
• You cannot operate the camera with the
shutter remote control in the following
cases:
– When the power save mode is canceled
– When you determine the part to be
trimmed (P109)
– When you determine the aspect ratio
conversion (P110)
REMOTE
DC IN 8.4V
AV OUT/
DIGITAL
VQT0X92.book 120 ページ ２００６年７月４日 火曜日 午前１０時３２分