Digital Camera User Manual

VQT2G62

Preparation

Inserting and Removing the Card (optional)/the

Battery

• Check that this unit is turned off.

• Close the flash.

• We recommend using a Panasonic card.

Slide the release lever in the direction of

the arrow and open the card/battery door.

• Always use genuine Panasonic batteries

(DMW-BLB13E).

• If you use other batteries, we cannot guarantee

the quality of this product.

Battery: Insert until it is locked by the

lever A being careful about the direction

you insert it. Pull the lever A in the

direction of the arrow to remove the

battery.

Card: Push it fully until it clicks being

careful about the direction you insert it.

To remove the card, push the card until it

clicks, then pull the card out upright.

B: Do not touch the connection terminals of the

card.

• The card may be damaged if it is not fully inserted.

1:Close the card/battery door.

2:Slide the release lever in the direction

of the arrow.

• If the card/battery door cannot be completely

closed, remove the card, check its direction and

then insert it again.

Note

• Remove the battery after use.

•

Do not remove the battery while the power is on as the settings on the camera may not be stored properly.

• The supplied battery is designed only for the camera. Do not use it with any other equipment.

• Before removing the card or battery, turn the camera off, and wait until the status indicator has

gone off completely. (Otherwise, this unit may no longer operate normally and the card itself

may be damaged or the recorded pictures may be lost.)

OPEN

LOCK

OPEN

LOCK

DMC-GF1GN-VQT2G62_eng.book 24 ページ２００９年８月２０日　木曜日　午前１１時７分