Operation Manual

- 101 -
Recording
Note
•
It will be a normal motion picture recording when recording a motion picture.
• Aperture or shutter speed can be set by touching [F] (aperture) or [SS] (shutter speed) and then
touching the exposure meter bar in the Quick Menu (P58).
• The brightness of the LCD monitor and the recorded pictures may differ. Check the pictures on
the playback screen.
• Set the aperture value to a higher number when the subject is too bright in Aperture-Priority AE
Mode. Set the aperture value to a lower number when the subject is too dim.
• When you use a lens with an aperture ring, the setting for the rear dial becomes effective if you
rotate the aperture ring to the [A] position and the aperture ring setting takes priority if you
rotate the aperture ring to a position other than [A] in Aperture-Priority AE Mode.
• The aperture value and the shutter speed displayed on the screen turn red and blink when the
exposure is not adequate.
• We recommend using a tripod when the shutter speed is slow.
• When the flash is activated, the shutter speed cannot be set to faster than 1/160th of a second
in Shutter-Priority AE Mode. (P75)
• If you press the shutter button fully when the shutter speed is slow, the shutter speed on the
screen counts down in Shutter-Priority AE Mode.
• [ ] and [ ] cannot be set for Shutter-Priority AE Mode.
• The [SENSITIVITY] is automatically set to [AUTO] when you switch the Recording Mode to
Shutter-Priority AE Mode while the [SENSITIVITY] is set to [ ] (Intelligent).