Information

5
Connections and interfaces
Setup support software PANATERM
Please download from our web site.
Braking resistor
(optional)
Encoder cable dedicated to a specific
model is available as an option.
DC Power supply
for brake DC24V
(to be supplied by customer)
Connect to external device,
e.g. feedback scale
(X5 connector is not installed on A5E series.)
Communication with host controller
(X2 connector is not installed on A5E series.)
Connection to PC
USB mini-B cable
(To be supplied by customer)
Lights while the main power is ON.
Controller
Junction cable
for motor
Junction cable for encoder
Connection to RS232,
RS485 or host controller
Connection to external scale
Connection to encoder
Connection to monitor output
Monitor output (digital: 1, analog: 2)
Connection to input power
Wiring of main connector
Use this connection when not configuring
a safety circuit. (standard accessories)
(X3 connector is not installed on A5E series.)
Connection to safety
by-pass plug
50-pin for I/O signals
Connection to host controller
Indicates parameters and errors
Front Panel
Charge lamp
Motor
Junction cable for brake
(optional)
Use this cable only
for a motor with brake.
[Connector type (100/200V: A to E-frame)]
Reactor (L)
Magnetic contactor (MC)
Noise filter (NF)
Circuit Breaker (MCCB)
(optional)
LED cover open
(optional)
Ground (earth)
<Caution>
Apply adequate tightening torque to the product mounting screw by taking into consideration strength of the screw and the
characteristics of material to which the product is installed. Overtightening can damage the screw and/or material;
undertightening can result in loosening.
Example) Steel screw (M5) into steel section: 2.7 to 3.3 N·m.
Mains
Residual
current device
Keys for incrementing/
decrementing digits
Display LED
Mode switching button
SET Button
Output connector
for monitor
6 1
Terminal block type
Frames F, G and H are
terminal block type.
Terminate the cable or
connect it to the terminal
block.
(Photo: F-frame)
Connector type (100/200V: A to E frame)