Owner manual

- 26 -
If an “F” Appears In The Display
Your Panasonic Combi Oven is equipped with a Self Diagnostic
Failure Code System; this means the oven monitors its own
operation and will show a failure code in the display window in the
unlikely event of a malfunction.
If a Failure Code appears in the display window (it will appear as an
“F” then a two digit number) follow these steps:
1. Close the door and switch off at socket. Ensure all air vents are
clear.
2. Leave 1 minute and then reconnect the oven at the mains.
3. Open the door and place food or a jug of water in the cavity,
close the door.
4. Try the same function that had been in operation prior to theb
appearance of the Failure Code in the display window.
If the Failure Code appears again, then contact the dealer from
which you purchased the oven, the manufacturer or a known
Approved Service Agent.
If a “U” Appears In The Display
A fault with the SD Memory Card will also show as a Failure Code
in the display window (it will appear as a “U” then a two digit
number). Follow the steps in the following chart.
When to Call a Service Engineer
CODE PROBREM
U16
U17
U19
SD Memory Card is
locked.
There is no
programme data
from this oven on
the SD Memory
Card.
Programme data of
a SD Memory Card
are damaged.
SD Memory Card is
not inserted.
WHAT TO DO
Take out the SD Memory Card & remove the
Lock. (see below).
Insert the SD Memory Card.
An SD Memory Card confirms that it is
attached to this oven. Please check whether
there is programme data from the oven on
the SD Memory Card in your personal
computer.
(See “Storing Programme Data on SD
Memory Card”)
When programme data is deleted, please
contact Service Engineer.
Remove the SD Card Cover & insert an
SD Memory Card.
LOCK
Recipe
Card
Lock is removed
when this part is
pushed up wards.