Manual

Watching One Show While
Record.rag Another on the
Hard Disk Recorder
Usa a cable splitter and attach RF cables to both the Hard
Disk Recorder and your television if you want to watch one
show while recording another show on the Hard Disk
Recorder.
1. Connect the incoming RF cable from the wall to the
IN jack on the 2-way splitter,
2. Connect an RF cable from one OUT jack on the 2-way
splitter to the ANT/CAW IN jack on the Hard Disk
Recorder.
3. Connect another RF cable from the other OUT jack
on the 2-way splitter to the VHF/UHF jack on your
television.
4. Follow the C ~ E instructions on page 9 for telephone
connection, AC power connection, and setup.
O
• Refer to your TV owner's manual for more information
on making connections to your television,
Splitter
TV
Hard Disk Recorder
,J
Attaching Satellite Receiver and Cable Box Controllers
ff you connect a satellite receiver or a cable box to the Hard Disk Recorder, you need to attach a controllercable so the Hard Disk
Recorder can change the channels on these devices. The controller, either a serial cable or an IR blaster cable, acts as a remote
control for these devices. When you press the Channel Up and Channel Down buttons on the Hard Disk Recorder remote control,
the channel is changed on your other device. See =Connectinga Sedal Cable" if your satellite receiverhas a asdal connector. If
your satellitereceiver or cable box does not have a serial connector, see =Connecting and Setting Up the IR Blaster" on page 17.
Connecting a Serial Cable
If the device you want the Hard Disk Recorder to control has a sadal connector, use the
supplied sedal cable instead of the supplied IR blaster.
1. Connect the serial cable to the SERIAL CONTROL port on the Hard Disk
Recorder. If your receiver has a 15-pin serial connector, use the supplied
15-pin to 9-pin adapter.
2. Connect the other end of the serial cable to the serial port on your other device.*
16