Installation Instructions

17
ENGLISH
5-5. Finishing the Installation
After finishing insulating and taping over the tubing, use sealing
putty to seal off the hole in the wall to prevent rain and draft
from entering. (Fig. 5-10)
Apply putty here
Tubing
Fig. 5-10
6. FINAL PROCEDURE
Reinstall the removed part to be placed in its original position.
(See the section “3-2. Preparation Before Installation”.)
Then install the accessory supplied side covers (L/R) on both
sides of the indoor unit.
● Attach the supplied side plates.
Insert the side plates in the direction of the arrow and fix
them with 2 screws once you’ve removed.
Side plate
Screw
Attach
● Attach the accessory supplied side covers.
Slide the covers from the front side and attach to the claws
of the latches.
Tighten the screws (accessory supplied).
Screw (accessory supplied)
Side cover (accessory supplied)
Fig. 6-1
● Attach the air-intake grille.
When attaching the air-intake grille, perform the reverse
procedure to removing the grille.
Refer to the section “3-2. Preparation Before Installation”.
Be sure to attach the safety string.
Close the air-intake grille and fix the claws of the latches with
the screws.
Safety string

Fig. 6-2
7. HOW TO INSTALL THE TIMER REMOTE
CONTROLLER (OPTIONAL PART)
NOTE
Refer to the Operating Instructions attached to the optional
Timer Remote Controller.
8. HOW TO INSTALL WIRELESS REMOTE
CONTROLLER RECEIVER
NOTE
Refer to the Operating Instructions attached to the optional
Wireless Remote Controller Receiver.
PAC-i_T2-type.indb 17PAC-i_T2-type.indb 17 2013/06/11 18:55:372013/06/11 18:55:37