Operating Instructions

ADJUSTING AIRFLOW DIRECTION

The functions differ depending on the indoor unit used. The airflow direction cannot be set

using the remote controller for any unit which is not listed below.

Y1 type, T1 type, K1 type:

• Never use your hands to move the flap (vertical airflow flap) that is controlled using the

remote controller.

• When the air conditioner is turned off, the flap (vertical airflow flap) automatically moves to

the downward position.

• The flap (vertical airflow flap) moves to the upward position when performing the standby

operation for heating. The swing operation is made after the standby operation for heating is

released, but swing is indicated on the remote controller even during the standby operation

for heating.

Setting the airflow

direction

The airflow direction changes each time the FLAP button is pressed during operation.

To activate the swing

operation

Press the FLAP button to set the flap (vertical airflow flap) to the downward position, and then

press the FLAP button again. This displays , and the airflow automatically swings up and

down.

To stop the swing

operation

Press the FLAP button again during the flap swing operation to stop the flap at the desired

position. Then, the airflow can be set from the top position by pressing the FLAP button again.

Indicator when swing operation is stopped

During cooling or drying operation, the flap will not stop at the downward position. Even if the

flap is stopped at the downward position during the swing operation, it will not stop until it

moves to the third position from the top.

Heating Cooling and drying Fan operation All operations

Set the flap (vertical airflow flap) to the downward

position. If the flap is set to the upward position,

the warm air may not reach the floor.

The flap (vertical airflow flap) can

be set to one of three positions.

Initial setting

Continuous

operation

Fan and heating Cooling and drying

01_85464609176013_EN.fm Page 8 Thursday, November 8, 2012 8:42 PM