Operating Instructions

6
Adjusting Airfl ow Direction

Using the wireless remote controller

Using the timer remote controller
Press / to select your desired airfl ow direction.

Flap swing motion
Display when swing operation
is stopped

Pressing the button during
swing operation can stop the
fl ap at the desired position.

Flap fi xed
(5 levels)
Recommended vertical airfl ow direction

Set the fl ap to the downward position for heating operation.
(With the upward setting, warm air cannot reach the fl oor.)

Set the fl ap to the upward position for cooling operation.
(With the downward setting, condensation may drip on to the
fl oor.)
U1, T2 type
HEAT COOL / DRY FAN
Airfl ow direction
display
Airfl ow direction display
“FLAP” button
“FLAP” button
Fan and
heating
Cooling and
drying
(5 levels) (3 levels)
Recommended
Recommended
Fixed to this
position

Adjusting the horizontal airfl ow direction
(Manual: T2 type only)
Move the horizontal airfl ow vanes
by hand for adjustment.
This section is described in the instruction manual supplied with the timer remote contoller (CZ-RTC2).
Regarding the High-spec Wired Remote Controller (CZ-RTC3), refer to the Operating Instructions supplied with the model CZ-RTC3.
Adjusting the upward and downward motion of airfl ow direction (U1 and T2 types only)
OI_00_F569616_EU.indb 6OI_00_F569616_EU.indb 6 2014/02/28 9:31:022014/02/28 9:31:02