Operating Instructions

8
WARNING

For safety, be sure to turn the air conditioner off and dis-
connect the power before cleaning.
(Otherwise, electric shock or injury may result because
the fan is rotating at high speed.)

Do not pour water on the indoor unit.
(This may damage the internal components and cause
an electric shock hazard.)
CAUTION

Never use solvents or harsh chemicals. Also, do not wipe
plastic parts using very hot water.
(This may cause deformation or change in colour.)

Some metal edges and fi ns are sharp. Be careful when
you clean those parts.
(Injury may result.)

Use a fi rm stool or ladder when cleaning an indoor unit
installed in high locations.

The internal coil and other components of the outdoor unit
must be cleaned periodically.
• Consult your dealer or service center.
Maintenance
Indoor unit
(e.g. U1 type)
Wash the fl ap for the air outlet with water.
(U1 type only)
• Be sure to stop the operation beforehand.
• After washing with water, allow it to dry, and then attach it
with the arrow facing outward.
Symptom Cause Action
The air
conditioner does
not operate
although the
power is turned
on.
Power failure or after power failure Press the power ON/OFF button on the remote controller.
The operation (power) button is turned off.
• If the breaker is turned off, turn the power on.
• If the breaker has been tripped, consult your dealer
without turning it on.
Fuse blow out. Contact your dealer.
Poor cooling
or heating
performance
The air intake or air outlet of indoor and
outdoor units is clogged with dust.
Remove the dust.
The wind speed switch is set to “Low”. Change to “High” or “Strong”.
Improper temperature settings
See “Tips for Energy Saving”. (P.7)
The room is exposed to direct sunlight in
cooling mode.
Doors or windows are open.
The air fi lter is clogged. See “Maintenance”. (P.8)
Too many heat sources in the room in
cooling mode.
Use minimum heat sources and in a short time.
Too many people in the room in cooling
mode.
Lower the temperature setting or change to “High” or
“Strong”.
If your air conditioner does not work properly even after checking each item of
“Before Requesting Services” and “Troubleshooting”

Stop the operation immediately and turn the power off. Then contact your dealer and report the serial number and symptom.
You also report if the inspection mark
and the letters E, F, H, L, P in combination with numbers appear on the LCD of the
remote controller.

Never repair the air conditioner by yourself since it is very dangerous for you to do so.
Before Requesting Services
Air outlet
Air intake
Wipe with a soft cloth.
(If it is very dirty, use
a cloth moistened with
water.)
OI_00_F569616_EU.indb 8OI_00_F569616_EU.indb 8 2014/02/28 9:31:032014/02/28 9:31:03