Network Operating Instructions Network Interface Unit WJ-NT314
Table Of Contents
- Preface
- Monitor Images on a PC
- Action at an Alarm Occurrence
- About the image recognition function
- Transmit Images onto an FTP Server
- About the Network Security of This Unit
- Display the Setup Menu and Configure the Settings of the Unit using a PC
- How to display the setup menu
- How to operate the setup menu
- Configure the basic settings of the unit [Basic setup]
- Configure the settings relating to images and audio [Camera setup]
- Configures the multi-screen settings [Multi-screen setup]
- Configure the AVMD settings [Video analytics setup]
- Configure the alarm settings [Alarm setup]
- Configure the settings relating to the authentication [Authentication setup]
- Configure the settings of the servers [Server setup]
- Configuring the network settings [Network setup]
- Maintenance of the unit [Maintenance]
- About the Displayed System Log
- Troubleshooting
22
Configure the settings relating to the NTP server [NTP]
Click the [NTP] tab on the "Basic setup" page. (☞ page 20)
The settings relating to the NTP server such as the NTP server address, port number, etc. can be configured on this
page.
[Time adjustment]
Select the time adjustment method from the following.
Manual setup: Time set on the [Basic] tab on the
"Basic setup" page will be used as the standard time
of the unit.
Synchronization with NTP server: Time automatically
adjusted by synchronizing with NTP server will be
used as the standard time of the unit.
Default setting: Manual setup
[NTP server address]
Enter the IP address or the host name of the NTP serv-
er.
Number of characters that can be entered: 1 - 128
characters
Default setting: (blank)
Important:
When entering the host name for "NTP server
address", it is necessary to configure the DNS set-
tings on the [Network] tab of the "Network setup"
page. (☞ page 51)
[NTP port]
Enter a port number to be used for the NTP server.
Available port number: 1 - 65535
Default setting: 123
[Synchronization interval]
Select an interval (1 - 24 hours: in 1 hour intervals) of
synchronization with the NTP server.
Default setting: 1 hour
[Time zone]
Select a time zone according to the location where the
unit is in use.
Default setting: (GMT) Greenwich Mean Time: Dublin,
Edinburgh, Lisbon, London