Network Operating Instructions Network Interface Unit WJ-NT314
Table Of Contents
- Preface
- Monitor Images on a PC
- Action at an Alarm Occurrence
- About the image recognition function
- Transmit Images onto an FTP Server
- About the Network Security of This Unit
- Display the Setup Menu and Configure the Settings of the Unit using a PC
- How to display the setup menu
- How to operate the setup menu
- Configure the basic settings of the unit [Basic setup]
- Configure the settings relating to images and audio [Camera setup]
- Configures the multi-screen settings [Multi-screen setup]
- Configure the AVMD settings [Video analytics setup]
- Configure the alarm settings [Alarm setup]
- Configure the settings relating to the authentication [Authentication setup]
- Configure the settings of the servers [Server setup]
- Configuring the network settings [Network setup]
- Maintenance of the unit [Maintenance]
- About the Displayed System Log
- Troubleshooting
![](/manual/panasonic/wj-nt314-1/network-operating-instructions-network-interface-unit-wj-nt314/images/img-37.png)
37
Set the depth manually
Step 1
Click the [SET] button of "Depth correction" on the
[AVMD] tab.
→ The "Depth correction" menu will be displayed.
Step 2
Select "Manual setup" for "Setup mode".
Step 3
Draw a marker by dragging the mouse between the
front side and rear side on the screen.
Notes:
• By dragging the mouse up and down, the size of
marker will become larger or smaller. (Horizontal to
vertical ratio is fixed to 1:3.)
• To retry drawing the marker, click [CLEAR] button.
• Assuming that people go forward and backward, it is
possible to calculate the correct depth by drawing
the larger marker for the nearer object (lower area in
the image) and the smaller marker for the farther
object (upper area in the image).
Step 4
After drawing the marker, click the [Execute] button of
"Depth calculation".
→ Calculation result is displayed in 3D on the screen.
Step 5
Click the [SAVE] button after completing the settings.
→ Returns to the "Detection area setup" menu.
Note:
Click the [RETURN] button to return to the
"Detection area setup" menu without setting the
depth.