Network Operating Instructions Network Interface Unit WJ-NT314
Table Of Contents
- Preface
- Monitor Images on a PC
- Action at an Alarm Occurrence
- About the image recognition function
- Transmit Images onto an FTP Server
- About the Network Security of This Unit
- Display the Setup Menu and Configure the Settings of the Unit using a PC
- How to display the setup menu
- How to operate the setup menu
- Configure the basic settings of the unit [Basic setup]
- Configure the settings relating to images and audio [Camera setup]
- Configures the multi-screen settings [Multi-screen setup]
- Configure the AVMD settings [Video analytics setup]
- Configure the alarm settings [Alarm setup]
- Configure the settings relating to the authentication [Authentication setup]
- Configure the settings of the servers [Server setup]
- Configuring the network settings [Network setup]
- Maintenance of the unit [Maintenance]
- About the Displayed System Log
- Troubleshooting
51
[Default gateway]
When not using the DHCP function, enter the default
gateway of the unit.
Default setting: 192.168.0.1
<Unavailable IP addresses for the default gate-
way>
0.*.*.*
*.*.*.0
255.*.*.*
*.*.*.255
127.0.0.1
Class D address (224.0.0.0 - 239.255.255.255)
Class E address (240.0.0.0 - 255.255.255.255)
* These IP addresses for the default gateway are
unavailable even when using the DHCP function.
Refer to the network administrator for the settings of
the DHCP server.
[HTTP port]
Assign the port numbers independently.
Available port number: 1 - 65535
Default setting: 80
[DNS]
Select "AUTO" or "MANUAL" to determine whether or
not to use the DNS.
When "MANUAL" is selected, it is necessary to config-
ure the settings for the DNS.
When using the DHCP function, it is possible to obtain
the DNS address automatically by selecting "AUTO".
Refer to the network administrator for further information
about the settings.
Default setting: MANUAL
[Primary DNS], [Secondary DNS]
When "MANUAL" is selected for "DNS", enter the IP
address of the DNS. Refer to the network administrator
about the IP address of the DNS.
Default setting: (blank)
[Line speed]
Select the line speed for data transmission from the fol-
lowings. It is recommended to use the default setting
"AUTO".
AUTO: Line speed will be applied automatically.
100M-FULL: 100 Mbps full-duplex
100M-HALF: 100 Mbps half-duplex
10M-FULL: 10 Mbps full-duplex
10M-HALF: 10 Mbps half-duplex
Default setting: AUTO
[FTP access]
Select "Allow" or "Forbid" to determine whether to allow
or forbid the FTP access.
Default setting: Forbid