Operating instructions

-14-
g. Title Editing
g-1. Move the cursor to “Data Title” by using the Right /
Left Switch.
g-2. Press the Set Switch.
The Camera Data Title screen is displayed on the
monitor.
Up to 12 characters can be selected.
** Cam1:------------ **
Down Load : Loading
Up Load :
Data Title *
Return
** Cam1 : Save **
Down Load : END
Up Load :
Data Title *
Return
• Up / Down Loading Screen
2-4. Press the Set Switch.
“Loading” is appeared and blinking during the
down load or up load.
Notes:
1. The previous data should not be kept.
After completing the up load or down load,
“Cam1 : Save” and “End” are displayed on
the down load or up load screen.
2. The up load or down load time is approx. 2
minutes per camera.
After completing the up load or down load,
the WV-CS600 will move to the Preset Position
(REFRESH).
3. The down loading or up loading data should
be the preset data only.
When you want to make the setting except the
preset data after up loading / down loading,
set them on the Camera Set Up Menu.
4. When the up load has been done to the
changed camera, the camera picture may not
be same with the previous one.
Set the camera condition with the Camera Set
Up Menu again.
5. The all preset data should be erased due to
the up load operation.
Save
• Error Display
When an error occurs during Up/Down Loading, the following messages are displayed on the monitor.
Message Cause Note
Error 1 Incompatibility of model
A difference between the transmission information
and the model occurs during up/down loading.
Error 2 Lack of memory
The transmission information is over the capacity in
memory during down loading.
Error 3 Causes except above
The up/down load is not possible due to something
cause except the above one.
** Cam1:------------ **
Down Load :
Up Load :
Data Title *
Return
g-3. Move the cursor to the desired character and
press the Set Switch.
g-4. To display the Preset Data screen, move the cur-
sor to the “Return” and press the Set Switch.
Notes:
1. When the title setting has not been made,
“SAVE” is displayed to the title position.
2. When the saved data is down loaded, the pre-
vious data is replaced to the down load data.
** Preset Data **
Cam1 : Save *
Cam2 : *
Return
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
0123456789
[].,'":;&#!?=
+-*/%$
←→ Space
Return Clear
Save........