Installation Manual

Table Of Contents

Page: 1 of 2

BT2HT, BT2HTI & RT2HT

PA25770A01

Rev. 02 8-201

HANDLE SPRING REPLACEMENT INSTRUCTIONS

Handle Return Spring part number: TB24796B01

1. Move the Back Handle away as

shown.

2. Turn the Tension all the way

down.

3. Flip the tool over and remove

the E-ring from the Mandrel

and put it aside.

4. Remove the Mandrel and put it

aside.

5. Remove the Ratchet and put it

aside.

PAGE 1
BT2HT, BT2HTI & RT2HT HANDLE SPRING REPLACEMENT INSTRUCTIONS © Panduit Corp. 2016 Handle Return Spring part number: TB24796B01 1. Move the Back Handle away as shown. 2. Turn the Tension all the way down. 3. Flip the tool over and remove the E-ring from the Mandrel and put it aside. 4. Remove the Mandrel and put it aside. 5. Remove the Ratchet and put it aside. Page: 1 of 2 PA25770A01 Rev.
PAGE 2
© Panduit Corp. 2016 BT2HT, BT2HTI & RT2HT HANDLE SPRING REPLACEMENT INSTRUCTIONS 6. Push both Bearings inside. 7. Remove the Front Handle. 8. Apply Grease (Versalube G326 or equivalent) on the Handle Spring and place it around the smaller Bearing. 9. Slide the Handle back into the Tool Body with Handle Spring. 10. Push the Bearings out to flush with Tool Bodies. 11. Make sure the dot on the Ratchet is towards you. Slide the Ratchet in. 12. Slide the Mandrel in and put the E-ring back on.