Installation Manual

© Panduit Corp. 2016
BT2HT, BT2HTI & RT2HT
HANDLE SPRING REPLACEMENT INSTRUCTIONS
Page: 2 of 2
6. Push both Bearings inside.
7. Remove the Front Handle.
8. Apply Grease (Versalube G326
or equivalent) on the Handle
Spring and place it around the
smaller Bearing.
9. Slide the Handle back into the Tool Body with Handle Spring.
10. Push the Bearings out to flush with Tool Bodies.
11. Make sure the dot on the
Ratchet is towards you. Slide
the Ratchet in.
12. Slide the Mandrel in and put the E-ring back on.
Email:
[e-mail]
EU Website:
www.panduit.com/emea
EU Email: emeatoolservicecenter
@panduit.com
www.panduit.com
Technical Support
Tel: [phone]
Panduit Europe • EMEA Service Center
Almelo, Netherlands
Tel: [phone] • Fax: [phone]