Component Guide

Transitioning Cables into the Network Element Bays
(continued from previous page)
Spill-over fittings can also be used to create exits over the
Network Element Bays. These fittings can be used during initial
installation or as a retrofit when a line-up is extended or new
equipment is added to the network. In the central office the
preference is to completely enclose the fiber optic jumper cables
transitioning from horizontal runs down into the equipment in the
Network Element Bays.
Components used in this detail include:
1. FRSP Spill-Over
2. FOV452X2 Outside Vertical 45° Angle Fitting
3. FIV452X2 Inside Vertical 45° Angle Fitting
4. HC2 FiberRunner
®
Hinged Cover
5. FZBA1.5X4 Adjustable “Z” Bracket (not visible)
6. H2X2 FiberRunner
®
Hinged Slotted Channel
7. FBC2X2 QuikLock
™
Coupler
Another option is to use flexible corrugated loom tubing from the
spill-over fitting to the 2x2 slotted hinged duct. This approach
eliminates the time required to position and secure multiple
individual fittings to create a protected pathway.
Components used in this detail include:
1. FRSP Spill-Over
2. FBC2X2 QuikLock
™
Coupler
3. FIDT2X2 Transition to 1.5'' ID Slit Corrugated LoomTubing
4. HC2 FiberRunner
®
Hinged Cover
5. FZBA1.5X4 Adjustable “Z” Bracket (not visible)
6. H2X2 FiberRunner
®
Hinged Slotted Channel
7. CLT150F 1.5'' Slit Corrugated Loom Tubing
C. Transitioning Cables into High Capacity Network
Element Bays
To provide a secure, accessible pathway to high density
Network Element Bays, the FRHD4KT 4x4 slotted hinged duct kit
can be used. The innovative, hinged cover opens easily from
either side without having to be removed from the duct, allowing
access to cables, reducing the time needed to make changes.
Components used in this detail include:
1. FRVT12X4 Vertical Tee
2. FRLPR64 6x4 to 4x4 Low Profile Reducer
3. FRHD4KT 4x4 Hinged Duct Vertical Cable Management Kit
The FRHD4KT Kit contains:
• 6' length, 4x4 Hinged Slotted Channel
• 6' length, 4'' Snap-On Hinged Cover
• Adapter to fit exit of 4x4 or 6x4 QuikLock
™
Vertical Tee or
6x4 to 4x4 Low Profile Reducer Fitting
• Three Adjustable “Z” Brackets, End Cap, and Wire Retainers
Cable Capacity
Comparison
2mm Fiber Optic Cable
1.6mm Fiber Optic Cable
2x2 Slotted
Hinged Duct
349
546
4x4 Slotted
Hinged Duct
1499
2343
11
1
2
4
6
7
3
1
1
3
2
2
4
6
7
5
5
2
3