Installation Manual

INSTRUCTIONS V00029AK

FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp

Page 1 of 2

Top of Cabinet Divider Wall - Screw Installation

• Pre-assemble screws and square nuts to divider wall

•

DO NOT completely tighten screws

- INSTALL -

[4] M6 Torx Screws

(use T25 Torx bit)

-A

CCESS

N-Type and S-Type Top of Cabinet

Divider Wall

(SN7TCDW, SN8TCDW

)

- INSTALL -

[4] M6 Square Nuts

PAGE 1
NET-ACCESS N-Type and S-Type Top of Cabinet Divider Wall (SN7TCDW, SN8TCDW) INSTRUCTIONS V00029AK © Panduit Corp. 2013 Top of Cabinet Divider Wall - Screw Installation • • Pre-assemble screws and square nuts to divider wall DO NOT completely tighten screws - INSTALL [4] M6 Torx Screws (use T25 Torx bit) - INSTALL [4] M6 Square Nuts FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.
PAGE 2
INSTRUCTIONS V00029AK Top of Cabinet Divider Wall - Installation • • • • • Position [2] square nuts of Top of Cabinet Divider Wall above [2] square cutouts of Top of Cabinet Cable Manager Insert [2] square nuts into square cutouts of Top of Cabinet Cable Manager Slide Top of Cabinet Divider Wall along slot until other set of [2] square nuts is above square cutouts Insert remaining set of [2] square nuts into square cutouts Slide Top of Cabinet Divider Wall to desired position and tighten screws - INSERT